Getting to Know Your Rendezvous
10
Seats
Memory Seats (if equipped):
On
equipped vehicles, memory seat con-
trols are located on the driver door
panel. Up to two drivers can program
their preferred seating positions and mir-
ror settings into memory. To store a set-
ting, adjust the seat and mirrors to the
desired positions. Press and hold mem-
ory button #1 for more than three sec-
onds. A second driver can store his or
her settings by repeating the process
and pressing memory button #2 for
more than three seconds.
To recall memory positions, the shift
lever must be in Park (P). To store an
exit position, press memory button #1 or
#2 (whichever driver number is yours)
and adjust the seat to a desired exit
position. Then press the exit button
below the numbered memory buttons for
more than three seconds.
To recall the exit position, the shift lever
must be in the Park (P) position. Press
the exit button and the seat will move to
the stored exit position.
To link seat and mirror memory settings
to the Remote Keyless Entry System
transmitter through the DIC, enter pro-
gramming mode (see DIC section of this
guide), press the MODE button until
SEAT RECALL appears and press the
SET button until the arrow points to the
desired ON or OFF position. If the ON
position is selected, press the MODE
button again until RECALL POSITION
appears. Press the SET button until the
arrow is before your choice of the MEM-
ORY or EXIT position. This selects the
automatic seat positioning when the
UNLOCK button on the key fob transmit-
ter is pressed.
See Section 3 of your Owner Manual.
Heated Seats (if equipped): The but-
tons to control this feature are located
on the instrument panel switchbank. The
left switch is for the driver seat and the
right switch is for the front passenger
seat. Press the top of the switch to turn
the heater on and the bottom of the
switch to turn if off. The switch will turn
off when the ignition is turned to OFF. If
the switch is left in the On position, the
heated seat feature will turn on when
the vehicle is restarted.
Note: This heated seat feature provides
a single level of heat. Also, it does not
shut off automatically once the seat(s)
are warmed. It must be turned off
manually.
To Next Page
Loading...
Need help?
General
