5
and then press and hold the SET
button until three chimes sound and
100% is displayed
For full engine oil information, see Section 5 of
your Owner Manual.
• Tire Pressure (Tire Inflation Monitor,
if equipped) indicates a large
pressure change in one tire, when the
vehicle is moving. See Section 5 of
the Owner Manual for full details.
• Select English or Metric units (USE
SET TO SELECT ENGLISH METRIC)
allows you to select English or metric
units of measure; the SET button tog-
gles between the choices.
• OFF turns off the DIC display three
seconds after it is selected. Press
the MODE button to turn the display
back on.
The DIC is used to program the choices
of two drivers. You will let the DIC know
which driver you are by using your
Remote Keyless Entry transmitter, which
was pre-programmed to belong to DRIV-
ER 1 or DRIVER 2. The vehicle will
recall the vehicle customization features
that were last programmed to correspond
to your transmitter. If you unlock your
vehicle using your key instead of your
transmitter, your vehicle will recall the
information from the last transmitter used.
Personalizing the DIC
• Enter Programming Mode by turning
the ignition key to ON with the trans-
mission in Park.
• Repeatedly press and release the
MODE button until PRESS SET
TO BEGIN PERSONALIZATION
is displayed; press the SET button.
• On the display, TO SELECT DRIVER
PRESS REMOTE LOCK appears.
Press the LOCK button on your key
fob transmitter. This identifies you
with the key fob signal and the
display now reads PERSONALIZA-
TION FOR DRIVER 1 or DRIVER 2,
indicating that it is ready to begin
programming.
Follow the DIC instructions on the
display to personalize each of the
following:
• Headlamp exit delay
• Interior lighting delay
• Interior lighting on
• Auto door lock/unlock
• Delayed locking
• Remote door unlock
• Lock/unlock feedback
• Seat recall
• Tilt mirror
Exiting Programming Mode
When you have reached the end of
the entire personalization list by
pressing the MODE button, the
PERSONALIZATION SELECTION
DONE message appears on the DIC
display, followed by PRESS SET TO
EXIT, MODE TO CONTINUE. To go
back through the list again, press
MODE. If you are satisfied with your
settings, press SET. You can also exit
programming mode by:
• Shifting the vehicle out of Park (P)
• Turning the ignition key out of the
ON position
• Not programming any commands for
one minute, while in the programming
mode
See Section 3 of your Owner Manual.
To Next Page
Loading...
Need help?
General
