1. Squeeze the angled latch release bar toward the
straight crossbar while placing the front hooks of
the bench seat onto the front two floor pins.
2. Make sure that the
bench seat is angled
so that the front
hooks clear the floor
pins. If the front
legs are not attached
correctly, the rear
legs will not attach
to the rear set of
floor pins.
3. Firmly push the rear hooks onto the rear floor pins
by pushing down on the rear of the seat.
4. Try to raise the seat to check that it is locked down.
5. Lift the seatback recliner lever and raise the
seatback until it locks upright.
6. Push and pull on the seatback to check that it is
locked upright.
7. Attach the lap belt.
1-12
To Next Page
Loading...
Need help?
General
