Taillamps, Turn Signal, Sidemarker,
Stoplamps and Back-up Lamps
To replace a taillamp, turn signal, sidemarker, stoplamp
or back-up lamp bulb:
1. Open the trunk. See Trunk on page 2-12.
2. Remove the convenience net.
3. Turn the four plastic wing nuts retaining the trunk
trim counterclockwise. There are two wing nuts
located on the driver side (shown) and two located
on the passenger side of the vehicle.
4. Pull back the trunk trim.
5. Turn the two wing nuts counterclockwise and
remove them.
6. Pull out the taillamp assembly and disconnect the
wiring harness.
5-50
To Next Page
Loading...
