To Next Page

To Previous Page

5. Say a name tag for the phone number. The name

tag is recorded and the system responds with

“About to store <name tag>. Does that sound OK?”.

• If the name tag does not sound correct, say

“No” and repeat Step 5.

• If the name tag sounds correct, say “Yes” and

the name tag is stored. After the number is

stored the system returns to the main menu.

Using the Digit Store Command

The digit store command allows a phone number to be

stored by entering the digits individually.

1. Press and hold

b g for two seconds. The system

responds with “Ready” followed by a tone.

2. Say “Digit Store”. The system responds with

“Please say the ﬁrst digit to store” followed by

a tone.

3. Say the ﬁrst digit to be stored. The system will

repeat back the digit it heard followed by a tone.

Continue entering digits until the number to be

stored is complete.

• If an unwanted number is recognized by the

system, say “Clear” at any time to clear the

last number.

• To hear all of the numbers recognized by the

system, say “Verify” at any time and the

system will repeat them.

4. After the complete number has been entered, say

“Store”. The system responds with “Please say the

name tag” followed by a tone.