On vehicles with a four-way lumbar control, press the
control forward or rearward to increase or decrease
support in the lower seatback. Press the top or bottom of
the control to raise or lower the support in the seatback.
The lumbar support may need to be re-adjusted when
changing the seating position.
Heated Seats
Your vehicle may have heated front seats. To operate
the heated seats, the ignition must be on.
The buttons are located on
the front doors.
J (Heated Seat Cushion and Seatback): Press this
button to turn on the heated seat cushion and seatback.
I (Heated Seatback): Press this button to turn on
the heated seatback.
When either button is pressed, an indicator light on that
button shows that the feature is on.
There are three temperature settings for each feature.
A column of three lights next to the buttons will display
which setting the feature is in: high, medium or low.
Three lights indicate the highest setting, two lights
indicate medium and one light indicates the lowest
setting.
When you press a button, the feature will turn on at the
highest setting. Each time you press the button, the
feature will decrease one temperature setting.
To turn the feature off, keep pressing the button until
the display lights turn off.
If your vehicle has remote vehicle start and is started
using the RKE transmitter, the front heated seats will be
turned on to the high setting if it is cold outside. See
“Remote Vehicle Start” under Remote Keyless Entry
(RKE) System Operation on page 3-5. When the key is
inserted into the ignition and the ignition is turned on, the
heated seat feature will turn off. To turn the heated seat
feature back on, press the desired button.
Driver’s Side Buttons
shown
2-6
To Next Page
Loading...
Need help?
General
