Buick 2011 Regal - Page 193

Black plate (35,1)
Buick Regal Owner Manual - 2011
Infotainment System 7-35
3. Say the name tag of the person
to call.
.
If the system recognizes
the name tag, it responds
“OK, calling <name tag>”
and dials the number.
.
If the system does not
recognize the name tag, it
confirms the name tag
followed by a tone. If the
name tag is correct, say
“Yes.” The system responds
with “OK, calling <name
tag>” and dials the number.
If the name tag is not
correct, say “No.” The
system will ask for the
name tag again.
Once connected, the person called
will be heard through the audio
speakers.
Using the Re‐dial Command
1. Press
b g.
.
For vehicles without a
navigation system, the
system responds “Ready,”
followed by a tone.
.
For vehicles with a
navigation system, the
system responds with a
tone. After the tone, say
“Hands Free.” The system
responds “Ready,” followed
by a tone.
2. After the tone, say “Re‐dial.” The
system responds “Re‐dial using
<phone name>” and dials the
last number called from the
connected Bluetooth phone.
Once connected, the person called
will be heard through the audio
speakers.
Receiving a Call
When an incoming call is received,
the audio system mutes and a ring
tone is heard in the vehicle.
.
Press b g.
.
Press $ i to ignore a call.
Call Waiting
Call waiting must be supported on
the Bluetooth phone and enabled by
the wireless service carrier.
.
Press b g to answer an
incoming call when another call
is active. The original call is
placed on hold.
.
Press b g again to return to
the original call.
.
To ignore the incoming call, no
action is required.
.
Press $ i to disconnect the
current call and switch to the call
on hold.