252 Vehicle Care
2. For the driver side bulb,
remove the windshield washer
bottle filler neck by firmly
pulling it straight up and out of
the bottle.
3. Remove the headlamp bulb
access cover.
4. Turn the bulb counterclockwise
and pull straight back.
5. Disconnect the wiring harness
connector from the bulb.
6. Install the new bulb in the
headlamp assembly by turning
clockwise.
7. Reconnect the wiring harness
connector.
8. Install the headlamp bulb
access cover.
9. For the driver side, reinstall the
windshield washer bottle filler
neck by firmly pushing it
straight into the bottle. Ensure
that the filler neck clip engages
into the underhood electrical
center retainer.
Parking/Turn Signal Lamp
1. Open the hood. See
Hood 0 230.
2. Remove the parking/turn signal
lamp bulb socket from the
headlamp assembly by turning
counterclockwise.
3. Remove the bulb from the bulb
socket by pulling it straight out.
4. Install the new bulb in the bulb
socket.
5. Install the bulb socket into the
headlamp assembly by turning
clockwise.
Fog Lamps
To replace the front fog lamp bulb:
1. Locate the bulb.
2. Remove the three screws
holding the closeout panel
under the front fascia.
3. Remove the bulb by turning it
counterclockwise and pulling
straight out of the assembly.
4. Disconnect the electrical
connector from the fog lamp
bulb assembly.
5. Install the new bulb by
engaging the locking tabs.
6. Reverse Steps 1–3 to reinstall.
Taillamps, Turn Signal,
Stoplamps, and Back-Up
Lamps
Trunk Deck Inboard Taillamp
and Back-Up Lamp
To Next Page
Loading...
