Instruments and Controls 5-33
If You Cannot See the HUD
Image When the Ignition Is On
.
Is anything covering the
HUD lens?
.
Is the HUD dimmer setting bright
enough?
.
Is the HUD image adjusted to
the proper height?
.
Are you wearing polarized
sunglasses?
.
Still no HUD image? Check the
fuse in the instrument panel fuse
block. See Instrument Panel
Fuse Block on page 10‑40.
If the HUD Image Is Not Clear
.
Is the HUD image too bright?
.
Are the windshield and HUD
lens clean?
If the HUD image is not correct,
contact your dealer.
Keep in mind that the windshield is
part of the HUD system.
Vehicle Messages
Messages displayed on the
DIC indicate the status of the
vehicle or some action that may be
needed to correct a condition.
Multiple messages may display
one after the other.
The messages that do not require
immediate action can be
acknowledged and cleared by
pressing SET/CLR. The messages
that require immediate action cannot
be cleared until that action is
performed. All messages should be
taken seriously and clearing the
messages does not correct the
problem.
Battery Voltage and
Charging Messages
BATTERY SAVER ACTIVE
This message displays when the
vehicle has detected that the battery
voltage is dropping beyond a
reasonable point. The battery saver
system starts reducing certain
features of the vehicle that you may
be able to notice. At the point that
features are disabled, this message
is displayed. It means that the
vehicle is trying to save the charge
in the battery. Turn off unnecessary
accessories to allow the battery to
recharge.
LOW BATTERY
This message is displayed when the
battery voltage is low. See Battery
on page 10‑25 for more information.
SERVICE BATTERY
CHARGING SYSTEM
This message is displayed when
there is a fault in the battery
charging system. Take the vehicle to
your dealer for service.
Brake System Messages
BRAKE FLUID LOW
This message is displayed when the
brake fluid level is low. See Brake
Fluid on page 10‑23.
To Next Page
Loading...
