Build A Spa ZEUS - Page 10

WWW . BUILDASPA . CO . UK | 0800 009 6430
ENQUIRIES @ BUILDASPA . CO . UK
THE ZEUS
LET ' S GET ST A RTED !
STEP THREE - PLUMBING THE HE A TING & JET SYSTEM
LOC A TE THE P A RT ON THE SHELL A S BELOW . IT IS DIRECTLY ON THE OPPOSITE SIDE TO THE M A NIFOLD A ND DIVERTOR SYSTEM WE WERE
WORKING ON IN STEP TWO .
SOLVENT WELD THE 3 COMPONENTS HIGHLIGHTED IN STEP 2 INTO THE A SSEMBLY IN STEP 3 .
PL A CE INTO THE FILTER RING A S IN STEP 4 . IT IS A DVIS A BLE TH A T YOU DO NOT SOLVENT WELD THIS IN POSITION UNTIL L A ST ON THIS
STEP .
USING THE 60MM OUTSIDE DI A METER PIPE , CUT A LENGTH OFF TO CONNECT A 45
DEGREE ELBOW COMING FROM THE SUCTION NUT ON THE SHELL , TO MEET THE TEE
MODULE WE PRE M A DE IN THE L A ST STEP . YOU M A Y NEED TO PRE A NGLE A LL OF
THESE PRIOR TO SOLVENT WELDING .
ONCE YOUR A SSEMBLY LOOKS LIKE THE FIN A L FIGURE ON THE LEFT , YOU C A N
SOLVENT WELD A LL THE JOINTS . REMEMBER TO BE GENEROUS IN YOUR CO A TINGS
A T THIS ST A GE A ND W A IT 10 SECONDS FOR THE JOINT TO WELD .
IT IS RE A LLY IMPORT A NT NOT TO RUSH THIS ST A GE A ND M A KE SURE A LL JOINTS
A RE SECURE .
FIGURE 14
FIGURE 15 FIGURE 16
FIGURE 17
FIGURE 18
FIGURE 19