Build A Spa ZEUS - Page 9

WWW . BUILDASPA . CO . UK | 0800 009 6430
ENQUIRIES @ BUILDASPA . CO . UK
THE ZEUS
LET ' S GET ST A RTED !
STEP TWO - PLUMBING THE JET WORK
WITH THE M A NIFOLD KIT ON THE LEFT SIDE NOW MOUNTED ONTO THE DIVERTOR , IT ' S TIME TO CONNECT THE PIPES . THE
PIPEWORK IS A LL PRE NUMBERED A ND LIKE IN THE PICTURE A BOVE , SHOULD CONNECT E A SILY . THERE A RE 12 PIPES TO
CONNECT . IT IS A DVIS A BLE A T THIS ST A GE TH A T YOU DO NOT PERM A NENTLY SECURE THEM WITH SOLVENT WELD UNTIL YOU
H A VE CONNECTED A LL PIPES TO THEIR A SSOCI A TED JETS A ND CONFIRMED TH A T THERE A RE NO SP A RE PIPES / JETS WITHOUT A
CONNECTION .
ONCE CONFIRMED A ND YOU H A VE CHECKED OVER THIS TWICE , YOU C A N SOLVENT WELD THEM IN POSITION . IT IS A DVIS A BLE TO
SOLVENT WELD THE JOINTS SEQUENTI A LLY FROM 1 - 12 R A THER TH A N THE JETS CLOSEST TO E A CH OTHER . TO SOLVENT WELD
THEM , YOU MUST REMEMBER TO A PPLY A CO A T ON THE SIDE OF THE JET , A ND A CO A T ON THE INSIDE OF THE PIPEWORK . HOLD
IN POSITION FOR 5 - 10 SECONDS PER JET TO GIVE THE SOLVENT WELD ENOUGH TIME TO WELD THE CONNECTION .
REPE A T A LL OF THESE STEPS FOR THE RIGHT H A ND SIDE M A NIFOLD
FROM THE PREVIOUS CHECKPOINT
FIGURE 11 FIGURE 12
FIGURE 13