Builders One Framed Cabinet - Drawer Adjustment Procedures; Drawer Removal and Insertion (Standard Runners); Partial Drawer Opening and Removal; Drawer Front Adjustment

3
DRAWER ADJUSTMENT - STANDARD RUNNERS (Shown without countertop for clarity)
Remove drawer from cabinet.
Firmly grasp runners at rear of
cabinet and slide toward center
of cabinet.
Insert drawer and fully close.
Open and close repeatedly to
align runners. See STEP 6
below.
STEP
1
STEP
2
STEP
3
Partially open drawer.
Reach underneath drawer box
at front. Locate runner releases
on each side, squeeze release
tabs and remove drawer.
Firmly grasp runners at rear of
cabinet and slide center of
cabinet.
DRAWER ADJUSTMENT - STANDARD RUNNERS (Shown without countertop for clarity)
STEP
1
STEP
2
STEP
3
Insert drawer and fully close
insuring that runners are locked
into releaser tabs. Open & close
repeatedly to align runners.
Rotate tab to raise or lower
drawer front on either side.
If additional adjustment is
required, loosen screws & twist
drawer front for proper alignment.
Tighten screws securely.
STEP
1
STEP
2
STEP
3
DRAWER FRONT ADJUSTMENT ADJUST DRAWER FRONT BEFORE INSTALLING DECORATIVE HARDWARE