Builders One Framed Cabinet - Hardware Installation and Door Alignment; Roll-Out Tray Relocation;Installation; Door Alignment - Height Adjustment; Door Alignment - Side to Side Adjustment

4
ROLL-OUT TRAY RELOCATION/INSTALLATION (Shown without countertop for clarity)
Determine desired location &
install plastic back boot in pre-
drilled holes. Attach with screws.
Repeat on opposite side.
Slide runner into back boot.
Repeat on opposite side.
Place roll-out spacer behind
runner. This spacer allows roll-
out tray to clear hinge when
opening. Install on hinge side
only. Double door cabinets
require spacers on both sides.
STEP
1
STEP
2
STEP
3
Attach runner to inside edge of
face frame. Repeat on opposite
side.
Install roll-out tray.
STEP
4
STEP
5
ADJUSTING DOOR ALIGNMENT
HEIGHT
Loosen center screw on
each hinge. Move door to
desired position. Re-tighten
each screw.
SIDE TO
SIDE
Using a Phillips screw
driver, rotate front screw
moving the door to desired
position.
DEPTH
Using a Phillips screw
driver, rotate back screw
moving the door to desired
position.