BullFrog STIL7 - Connecting the electrical service to the spa

43
Step 1:
Choose one of the three available conduit entry points.
(Yellow Black decal)
Step 2: Determine the conduit diameter and drill a hole that
is properly sized for the conduit (¾” conduit drill 1-1/8” hole, 1”
conduit drill 1-3/8” hole). Use the + as the locater for the center
of the hole. e hole saw must go through two layers of plastic.
ere is a 1” space between both layers.
Step 3: Push the conduit through the hole until it comes out
into the equipment area.
Step 4: Remove the faceplate to the Control System Box
Step 5: Connect the conduit to the Control System Box using a
Liquid Tight Connector.
Step 6: Run the required wires through the conduit to the
Control System Box.
Step 7: Connect the electrical service wires to the terminal
block located in the Control System Box.
Step 8: Replace the Control System Box faceplate and the
equipment compartment door. e electrical hook-up is complete.
Note: To conform with electrical codes, and to create a barrier
against pests, any holes created in the base of your Bullfrog Spa
should be tted with an appropriate connector.