Bultaco SHERPA T 74 1978

Need help?

Do you have a question about the Bultaco SHERPA T 74 1978 and is the answer not in the manual?

Summary

II. THE LAYOUT

B. THE CLUTCH

Describes the clutch's location, type, and operation.

C. THE GEARBOX

IV. LUBRICATION

A. LUBRICATION DURING A TRIAL

B. LUBRICATION BEFORE AND AFTER EACH TRIAL

C. LUBRICATION AFTER 6 TRIALS

VI. DETAILED MAINTENANCE PROCEDURES

A. SPARKPLUG

1. General

B. CARBURETER

Cleaning the Air-Cleaner Element

Cleaning the Carbureter Fuel Filter

Adjusting the Play in the Throttle Cable

How to adjust throttle cable free play for optimal response.

Adjusting the Idle

Steps to set the correct idle speed and mixture.

Changing the Main Jet

C. IGNITION TIMING

2. Checking the Ignition Timing

Procedure for checking ignition timing with a vernier gauge.

3. Points setting

How to set the breaker points gap for ignition timing.

D. THE CLUTCH

1. Using the Clutch Cable Adjuster

2. Adjusting the Clutch Operating Shaft Assembly

Adjusting clutch linkage for proper operation.

3. Installing a New Clutch Cable and Sheath Assembly

E. THE FRONT WHEEL

2. Removing the Front Wheel

3. Reassembling the Front Wheel

F. THE FRONT BRAKE

1. Using the Cable Adjuster

3. Adjusting the Brake Arm

4. Changing the Brake Cable and Sheath Assembly

5. Cleaning the Brake Linings

G. THE REAR CHAIN

1. Tightenings the Chain

2. Changing the Chain

3. Cleaning and Greasing the Chain

H. THE REAR WHEEL

2. Removing the Rear Wheel

J. THE REAR BRAKE

1. Using the Tensor

2. Taking up the Brake Wear

Adjusting for rear brake lining wear.

3. Cleaning the Brake Linings

VII. CLEANING THE MOTORCYCLE

1. Washing the Motorcycle

2. Polishing the Motorcycle

VIII. DETAILED SPECIFICATION

1. ENGINE

Engine specifications for 74 and 125 models.

2. CARBURETER

Carbureter specifications for ZENITH and AMAL types.

3. TRANSMISSION

Gearbox, primary, and secondary transmission specifications.

4. CLUTCH

Clutch type, oil, and capacity specifications.

5. ELECTRICAL EQUIPMENT

Specifications for the electrical system components.

6. SPARKPLUG

Sparkplug specifications and recommended types.

7. FRONT SUSPENSION

Front suspension type, oil, and travel specifications.

8. REAR SUSPENSION

Rear suspension type, travel, and shock absorber specifications.

9. WHEELS

Wheel rim and tyre specifications.

10. BRAKES

Brake system dimensions.

11. GENERAL CHARACTERISTICS