12
CLEANING THE SPRAYHEAD
Cleaning the sprayhead tube removes deposits formed
by natural mineral content in your water. The more
mineral content in your water, the more you should clean.
A good rule of thumb is to clean it every 3 months.
If you have very hard water, then twice a month may
be necessary.
You will need: a toothpick, dish soap, and a soft cloth.
• Press the tank power switch to the OFF position, unplug
the coffee maker and allow it to cool for at least 2 hours.
• Remove the funnel and unscrew the sprayhead,
loosening with your ngertips.
• Reinsert funnel in machine.
• Pour a carafe of fresh water into the coffee maker.
Keep lid open.
• Place the empty carafe under the funnel and close the
lid. Water will ow into the carafe.
• Check the sprayhead holes and clear any deposits
with the toothpick.
• Clean the sprayhead with a cloth and dish soap.
Rinse with water.
• Empty the water from the carafe and replace the empty
carafe under the funnel.
• Remove the brew funnel and reinstall the sprayhead.
Reinsert the brew funnel.
• Plug in the coffee maker. Press the tank power switch
to the ON position.
• Wait 15 minutes for the water in the tank to reach
brew temperature.
• Your machine is again ready for brewing.
*NOTE: For a replacement sprayhead, call customer service at
1-800-352-2866 (USA) or 1-800-263-2256 (Canada).
To Next Page
Loading...
Need help?
General
