What to do if my Bunn SBS Brewing Systems coffee maker makes a rumbling noise?
A rumbling noise in your Bunn Brewing System coffee maker often indicates lime build-up on the heater. To resolve this, clean the unit following the instructions provided in the ROUTINE CLEANING section of the manual.
How to stop water flowing before the lid is closed on Bunn Brewing Systems?
If water flows before the lid is closed on your Bunn Brewing Systems coffee maker: * Ensure the lid is completely open to properly activate the rubber stopper inside the pour-in bowl. * Keep in mind, the coffee maker isn't designed to hold water in the pour-in bowl overnight. * Check that the rubber stopper is correctly placed and the area is clean by removing the top cover.
Why is my Bunn SBS coffee cold?
If your Bunn Brewing System coffee is cold, it might be because the tank didn't reach the correct temperature before brewing. Ensure the coffee maker is plugged in and the Tank Power Switch is turned ON. If it wasn't on, allow approximately 15 minutes for the tank to heat up to the required operating temperature.
Contact information for product support and questions.
Instructions and link for registering the coffee maker.
Guidelines for cleaning standard Speed Brew models, including dishwasher safety.
Specific instructions for cleaning thermal carafe models and components.
Explains potential causes and solutions when coffee is not hot enough.
Addresses the cause of rumbling noises and cleaning recommendations.
Explains issues with water flow and lid closure.
Discusses causes of funnel overflows and filter usage.
General| Manufacturer | Bunn |
|---|---|
| Model | SBS |
| Category | Brewing Systems |
| Water Source | Pourover |
| Power | Electric |
| Voltage | 120V |
| Wattage | 1500W |
| Cord Attached | Yes |
| Material | Stainless Steel |
To Next Page
