Burco 69795 - 11.0 Cleaning Instructions

19 08/54070/0 (Issue 5)
11.0 Cleaning Instructions
It is recommended that your water boiler is cleaned on a regular basis. Failure to do so may result in the
appliance not operating to its full potential and may invalidate your warranty.
Disconnect from the electrical supply before cleaning and allow water boiler to cool.
Do not immerse the water boiler in water or any other liquids and take care to keep water away
from the supply cord and connections. Do not use a water jet or steam cleaner.
External Cleaning
Wipe the external surfaces & dispensing tap of the appliance with a damp cloth. It is recommended that
this is done daily to prevent lime scale build up. Stubborn stains may be removed using a good stainless-
steel cleaner or non-abrasive cleaner. Hard to reach areas should be cleaned using a soft brush & mild
cleaning solution.
Failure to clean on a regular basis may invalidate your warranty
12.0 Troubleshooting
If you experience any problems with the water boiler, please contact our Aftersales team on +44 [0]344
879 3588. To ensure we can offer you the best possible service, please ensure you have the product code
and serial number available (from page 2).
6. Press & hold the UP &
DOWN buttons for 3
seconds to reset filter alarm
on controller.
5. Twist new cartridge
clockwise until locked in
position
4. Twist cartridge
anticlockwise to remove
(some residual water may
be present).
Failure to use the correct filter cartridge will affect performance and invalidate the boilers
warranty.