Installing Wheel Guard Tube
1. With wheel guard tube ends facing toward the wheels
(away from the trailer front), match holes in wheel guard
tube to holes in center of trailer bottom side frame.
2. Insert screws and, using provided hex key wrench, tighten
securely. PHOTO 1
Opening Your Trailer
1. Rotate front tube upward and rear tube back until they
meet on plastic saddles. FIGURE 1
2. Rotate frame locks and snap onto rear tube. FIGURE 2
To view a video clip of “Folding a Burley” go to:
www.burley.com/support/tutorials.cfm.
PHOTO 1: Trailer bottom
CHECK THAT THE FRAME LOCKS ARE PROPERLY ENGAGED
BEFORE USING THE TRAILER. FAILURE TO DO SO CAN RESULT IN
SERIOUS INJURY.
WARNING
FIGURE 1
FIGURE 2
Frame Locks
Rear
Front
Plastic Saddles
Screws
Trailer Front
To Next Page
Loading...