HOOKUP TO AN ANALOG AMPLIFIER
Analog outputs To connect an analog amplifier or receiver the 061 offers balanced as well as unbalanced
outputs. If your amplifier or receiver provides balanced inputs connect them to the terminals
BALANCED R (29) and BALANCED L (32). Unbalanced connections can be made using
the terminals UNBAL (30). An analog recording device may be hooked up to the terminal
TAPE (31).
For reasons of superior sound we recommend using balanced connections whenever
possible.
The pinning of the balanced outputs are: PIN1=GND, PIN2=NEG, PIN3=POS.
ADDITIONAL CONNECTIONS
MMI slot (optional) The MMI slot (19) offers to integrate future developments into the CD player 061, for
example a multi media interface.
REMOTE Connecting DC OUT (22) to the corresponding DC IN-jack of another BURMESTER-unit
offers to switch on or off this other unit simultaneous by the 061. In this case, 061 has the
master function.
Connecting DC IN (23) to the corresponding DC OUT-jack of another BURMESTER-unit
offers to switch on or off the 061 simultaneous by the other unit. In this case, 061 has the
slave function.
BURLINK(optional) To the BURmester-LINK interface plugs (17), (18) a computer system like PC,
CRESTRON
®
, Nevo e.g. can be connected to the CD player 061. The computer system
allows a comfortable control of your hifi system using an individual programmable touch
panel for example. With the LEDs beside the plugs named T and R (Transmit and Receive)
you can check whether data exchange is working.
The BURLINK module is available on request at your local dealer.
To Next Page
Loading...
Need help?
General
