5. Make sure no air condition, chimney or other heat resources in
the camera’s field of view. Rising sun or sunset may trigger the
PIR, pay attention to the camera orientation.
6. If wireless camera stops sending, please check the balance of
SIM card or data plan condition. Check if signal is stable there.
7. When default the camera, all settings would be set to factory
settings.
8. Video could be sent at camera mode(video) and send
mode(instant), but make sure camera registered to high speed
3G/4G network. If video clip size larger than 25MB, sending would
be stopped and changed to WVGA 10s from next trigger.
9. Highly recommend to test the network speed by send a picture
manually in the field before finish the setup. If registered to 2G
network, please don’t try to send original photo or video clip.
10. Camera goes to setup mode when camera switch move from OFF
to ON, if no operation for 5 minutes, camera goes to working
mode automatically. Press left button for 1 second and then press
OK at preview mode, it goes to working mode immediately.
11. SMS control explanation. Always, camera ready to reply SMS
command all the time, consume a lot power. Every n hours,
camera SMS turn on for 0.5 hour, then turn off for n-0.5 hours;
repeat this again and again. Off, SMS control=Off.
12. How to send a picture manually? After network found at preview
mode, with right wireless settings, camera mode=photo, send
mode =instant; press OK, a picture would be taken first, then you
can choose send this photo or not.
To Next Page
Loading...
