BUSCH PANDA WV 1200 A

Questions and Answers

T
Thomas NelsonAug 11, 2025
What to do if my BUSCH PANDA WV 1200 A does not start?
- J
  Jacob DicksonAug 11, 2025
  If your BUSCH Extender doesn't start, several issues could be the cause. First, check the power supply to ensure the motor is receiving the correct voltage. If the power is ok, the lobes might be jammed; in this case, lobes inspection or repair the machine (contact Busch). Another possibility is that solid foreign matter has entered the machine; remove any foreign matter and consider equipping the machine with a mesh screen at the suction connection. Finally, the motor itself might be defective, requiring replacement.
E
Elizabeth WellsAug 16, 2025
Why is my BUSCH PANDA WV 1200 A Extender running too hot?
- R
  Rose PageAug 17, 2025
  If your BUSCH Extender is running too hot, it could be due to several reasons. The ambient temperature might be too high, so ensure it's within the permitted range. The temperature of the process gases at the inlet could also be too high; check that it is within the permitted limits. Additionally, a low oil level can cause overheating, so top up the oil as needed. The backing pump might not be correctly defined, so contact Busch.
J
Justin NewmanAug 23, 2025
What to do if my BUSCH PANDA WV 1200 A Extender does not reach the usual pressure?
- A
  Anthony NicholsAug 23, 2025
  If your BUSCH Extender isn't reaching its usual pressure, it could be due to several factors. Check if the suction or discharge lines are too long or have a section diameter that's too small; use larger diameter or shorter lines. The machine may be running in the wrong direction; check the direction of rotation. Internal parts may be worn or damaged; repair the machine (contact Busch).
A
Autumn CoxAug 28, 2025
Why is my BUSCH PANDA WV 1200 A Extender running very noisily?
- Z
  zwilliamsAug 29, 2025
  If your BUSCH Extender is running very noisily, it could be due to a wrong oil quantity or unsuitable oil type; use one of the recommended oils in the correct quantity. Alternatively, there may be defective gears, bearings, or a coupling element; repair machine (contact Busch).
T
tdunnSep 4, 2025
Why is the oil in my BUSCH PANDA WV 1200 A Extender black?
- S
  Stephen MaldonadoSep 4, 2025
  The oil in your BUSCH Extender might be black because the oil change intervals are too long; drain the old oil and fill it with new oil. The machine may be running too hot.

BUSCH PANDA WV 1200 A Specifications

General

Brand	BUSCH
Model	PANDA WV 1200 A
Category	Extender
Language	English

BUSCH PANDA WV 1200 A - User Manual

Table of Contents

Questions and Answers

BUSCH PANDA WV 1200 A Specifications