BUSCH Panda WV 1500 C

Questions and Answers

S
Shelley ByrdAug 9, 2025
What to do if my BUSCH Panda WV 1500 C Industrial Equipment does not start?
- A
  Amy WashingtonAug 9, 2025
  If your BUSCH Industrial Equipment isn't starting, it could be due to several reasons. First, check the power supply to ensure the motor is receiving the correct voltage. Another possibility is that the lobes are jammed or seized, requiring inspection or repair, which may necessitate contacting Busch. Solid foreign matter might have entered the machine; if so, remove it and consider equipping the machine with a mesh screen at the suction connection. Lastly, the motor itself could be defective, in which case it should be replaced.
K
karen13Aug 15, 2025
Why is my BUSCH Industrial Equipment running too hot?
- H
  Harold WellsAug 15, 2025
  If your BUSCH Industrial Equipment is running too hot, there are several potential causes. The ambient temperature or the temperature of the process gases at the inlet may be too high; ensure you observe the permitted temperatures. Additionally, check the oil level and top it up if it is too low. It is also possible that the backing pump is not correctly defined and you should contact Busch.
K
kcampbellAug 21, 2025
What to do if my BUSCH Panda WV 1500 C does not reach the usual pressure?
- M
  Mark SmithAug 21, 2025
  If your BUSCH Industrial Equipment isn't reaching its usual pressure, several factors could be the cause. Check if the suction or discharge lines are too long or have a section diameter that's too small; using larger diameter or shorter lines may help. You may need to contact your local Busch representative for advice. Also, verify the machine's direction of rotation against the wiring diagram. Internal parts might be worn or damaged, requiring you to contact Busch to repair the machine. The backing pump might not be correctly defined, in this case you should contact Busch.
J
James CampbellAug 27, 2025
How to fix a noisy BUSCH Industrial Equipment?
- R
  Rodney RyanAug 28, 2025
  If your BUSCH Industrial Equipment is running very noisily, it could be due to the wrong oil quantity or an unsuitable oil type; use one of the recommended oils in the correct quantity. Alternatively, defective gears, bearings, or the coupling element could be the cause, requiring you to contact Busch to repair the machine.
P
patrickgreeneSep 2, 2025
Why is the oil in my BUSCH Panda WV 1500 C black?
- J
  Joshua SmithSep 2, 2025
  If the oil in your BUSCH Industrial Equipment is black, it could be because the oil change intervals are too long; drain the old oil and fill in new oil. Also, the machine might be running too hot, so refer to the troubleshooting steps for that specific problem.