If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions.
28
Care and maintenance
Looking after your appliance
Care and maintenance
Cleaning and Maintenance
Disconnect the unit from the power supply
before cleaning.
Do not wash your appliance by pouring water
on it.
Do not use abrasive products, detergents or
soaps for cleaning the appliance. After
washing, rinse with clean water and dry carefully.
When you have finished cleaning, reconnect the
plug to the mains supply with dry hands.
• Make sure that no water enters the lamp
housing and other electrical components.
• The appliance should be cleaned regularly
using a solution of bicarbonate of soda and
lukewarm water.
• Clean the accessories separately by hand with
soap and water. Do not wash accessories in a
dish washer.
• Clean the condenser with a brush at least
twice a year. This will help you to save on
energy costs and increase productivity.
The power supply must be disconnected
during cleaning.
Defrosting
• Your appliance performs automatic
defrosting. The water formed as a result
of defrosting passes through the water
collection spout, flows into the vaporisation
container behind your appliance and
evaporates there.
• Make sure you have disconnected the
plug of your appliance before cleaning the
vaporisation container.
• Remove the vaporisation container from its
position by removing the screws as indicated.
Clean it with soapy water at specific time
intervals. This will prevent odours from
forming.
Replacing the Light Bulb
Important note: Unplug the unit from the
power supply before start the process.
1
2
3
4
1. Press the hooks on light cover. (Fig. 1)
2. Open the light cover towards arrow when top
hooks pull out from housing. (Fig. 2)
3. Pull out the cover towards arrow remove it. (Fig.
3)
4. Turn the light bulb counter clockwise and
remove it. (Fig. 4)
5. Change the present light bulb with a new one of
not more than 15 W. (Fig. 4)
6. Implement the steps in reverse order.
7. After waiting 5 minutes, plug the unit.
Replacing LED Lighting
If your fridge has LED lighting contact the Bush
helpline as this should be changed by
authorized personnel only.
To Next Page
Loading...
