If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions.
26
Care and maintenance
Looking after your appliance
Care and maintenance
Replacing the LED Lighting
If your fridge has LED lighting contact the Bush
helpline as this should be changed by
authorized personnel only.
Cleaning and maintenance
General
• Disconnect the unit from the power supply
before cleaning.
• Do not clean the appliance by pouring water.
• Make sure that no water enters the lamp
housing and other electrical components.
• The appliance should be cleaned periodically
using a solution of bicarbonate of soda and
lukewarm water.
• Clean the accessories separately with
soap and water Do not clean them in the
dishwasher.
• Do not use abrasive products, detergents or
soaps. After washing, rinse with clean water
and dry carefully. When you have finished
cleaning, reconnect the plugto the mains
supply with dry hands.
• Clean the condenser with a broom at least
twice a year. This will help you to save on
energy costs and increase productivity.
! THE POWER SUPPLY MUST BE
DISCONNECTED.
Defrosting
Your fridge - freezer has fully automatic defrosting.
The water formed as a result of defrosting passes
through the water collection spout, flows into the
vaporisation container below the condenser and
evaporates there.
Evaporation container
Refrigerator LED light
and cover
To Next Page
Loading...
