If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
14
Installing and Operating Your Fridge
- Freezer
Before starting to use your fridge - freezer, you
should pay attention to the following points:
• Operating voltage for your fridge - freezer is
220-240 V at 50Hz.
• We do not take the responsibility of the
damages that occur due to ungrounded
usage.
• Do not place your appliance in direct sunlight.
• Your appliance should be at least 50 cm away
from stoves, gas ovens and heater cores, and
should be at least 5 cm away from electrical
ovens.
• Your fridge - freezer should never be used
outdoors or left under the rain.
• When your fridge - freezer is placed next to
a deep freezer, there should be at least 2 cm
between them to prevent humidity on the
outer surface.
• Do not place anything on your fridge -
freezer, and install your fridge - freezer in
a suitable place so that at least 15 cm is
available on the upper side.
• The adjustable front legs should stabilized in
an appropriate height to allow your fridge -
freezer operate in a stable and proper way.
You can adjust the legs by turning them
clockwise (or in the opposite direction). This
should be done before placing food in the
fridge - freezer.
• Before using your fridge - freezer, wipe all
parts with warm water added with a tea
spoonful of sodium bicarbonate, and then
rinse with clean water and dry. Place all parts
after cleaning.
• Install the distance adjustment plastic (the
part with black vanes at the rear) by
turning it 90° as shown in the figure
to prevent the condenser from
touching the wall.
• Fridge - freezer should be placed against a
wall with a free distance not exceeding 75
mm.
Before Using Your Fridge - Freezer
• Before switching on your appliance for the
first time, ensure it is positioned in it’s desired
final location and is in it’s upright position
for at least 3 hours before plugging in and
switching on the power. Otherwise you may
damage the compressor.
• You may experience a odour from the
appliance when it is operated for the first
time. This is normal and will fade when your
appliance starts to cool.
Shipment and Repositioning
• Original package and foam may be kept for
retransportation (optionally).
• You should fasten your fridge - freezer with
thick package, bands or strong cords and
follow the instructions for transportation on
the package for retransportation.
• Remove movable parts (shelves, accessories,
vegetable bins etc.) or fix them into the fridge
- freezer against shocks using bands during
repositioning and transportation.
Carry your fridge - freezer in the upright position.
Installing your Built-In Combi Fridge - Freezer
Installing your Built-In Combi Fridge - Freezer
Bringing it all together
To Next Page
Loading...
