Care and maintenance
1.Clean with water only; do not use hard/sharp-edged objects!
Do not operate the dryer without the air condenser!
2.During drying, water may collect between the window
and the seal, but this does not affect the function of
your dryer!
!
Cleaning the condenser
The condenser is situated at the lower part of
the cabinet behind a small door. To open the
door, push the catch as per picture above.
During the drying cycle or at the end, it is
normal for water to be present on the surface
of the condenser unit(Fig9).
To pull out the condenser, first turn the two
red stops downwards and then remove the
condenser unit holding it at the handle(Fig10).
Clean it with a brush and rinse it under the
shower if necessary(Fig11).
Also clean the outside, removing all fluff.
Clean the rubber seal round the condenser
cabinet and in the inner part of the small door
with a damp cloth.
Important! Do not use pointed objects
or utensils to clean the spaces between
the plates, as this could damage the
condenser and make it permeable.
Re-fit the condenser, turn the red stops
upwards and close the door.
Do not use this appliance if the condenser
has not been fitted.
Fig9
!
!
Fig10
Fig11
To Next Page
Loading...
