28
Care and maintenance
NOTE!
of drying time and consumption; therefore, the scrap thread filter shall be cleaned after each use.
1.The lint filter accumulated on the filter will block the air circulation, which will cause the extension
2.Do not operate the dryer without the lint filter !
3.Clean the lint filter after each use to prevent lint accumulation inside the dryer.
Cleaning the door
Periodically clean the interior part of the door to
remove any fluff from the seals around the filter.
Accurate cleaning ensures correct drying(Fig4).
4.The icon will flash to remind you to clean the filter.
Cleaning the filter:
1.Open the loading door.
2.Remove the cover filter by pulling it up and open the filter . (Fig5,6)
3.Clean lint,fibre,and cotton raveling by hand or with a soft
piece of cloth . (Fig7,8)
4.Close the filter and place it back into its seat.
Do not be alarmed by the amount of fluff. It is not due to excessive
wear caused by the dryer.
All fabric loses fluff when drying but it goes unnoticed in the air.
In a tumble dryer it simply collects in the filter.
After a while, a whitish film due to detergent residue on laundry
forms on the filters. When this occurs, clean the filters with warm
water using a brush.
NOTE!
Fig4
Fig5
Fig6
Fig7
Fig8
General
Important: Always unplug the appliance from the power socket during cleaning and
maintenance.
Never use any sharp instruments or abrasive substance, soap, household cleaner, detergent or wax
polish for cleaning.
Use luke warm water to clean the cabinet of the appliance and wipe it dry.
Never clean the appliance with flammable fluids. It could cause a damage and fire hazard.
Clean the exterior of the appliance, inner tube and door seal with a damp cloth. Open the door for
aeration to dry the inner tube through.
Avoid water going in the control panel. Clean with a dry cloth only.
Clean the lint filter after each use.
To Next Page
Loading...
