Bush DLED48287FHD - User Manual

3
2
Connect the antenna to your TV
Connect the TV to the mains socket
...and switch on
insert plug...
UK plug
4
To switch the TV on
Insert the batteries into the Remote Control
1
Lift the cover on the back of the remote gently. Insert two
AAA batteries. Make sure the (+) and (-) signs match
(observe correct polarity). Place the cover back on.
1. Connect the power cord to the 220-240V AC, 50 Hz.
Then the standby LED lights up.
To switch on the TV from standby mode either:
2. Press the “ ” button, P/CH+ / P/CH- or a numeric button
on the remote control or;
3. Press the control switch located on the left side of the
TV.
By either method the TV will switch on.
REAR OF THE TV
Quick Start Guide
DLED48287FHD
Helpline No: 0345 6040105

Summary

Insert Batteries into Remote Control

Connect Antenna to TV

Connect TV to Mains Socket

Switch the TV On

HDMI Input

Start Auto Setup Procedure

Select Language

Choose the desired language from the initial on-screen display and confirm.

Configure First Time Installation

Set desired options using navigation buttons during the first time installation screen.

Start Automatic Channel Scan

Initiate a scan for digital terrestrial broadcasts and optionally sort channels by LCN.

Bush DLED48287FHD Specifications

General

Brand	Bush
Model	DLED48287FHD
Category	LED TV
Language	English