Bush Wi-768 - Aux In Mode Operation

Using your Bluetooth Speaker with Wi-Fi
Let’s get started
Using your Bluetooth Speaker with Wi-Fi
22
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Tro ubles hoot ing
Aux in mode
Check that your Bluetooth Speaker with Wi-Fi is in Aux in mode. If you are not already in
Aux in mode, short press the Power/Mode button on the back of the speaker until you are
in Aux in mode. The LED ring on the top of the speaker will be red, continuously on.
1. Connect one end of a 3.5mm audio cable (not supplied) to the headphone (or
auxiliary out) socket of your secondary device. Connect the other end to the Aux in
socket on the back of your speaker.
2. Press the Play button on your external device to start playback through the speaker.
3. To gain optimal volume levels, adjust the volume level on both the secondary device
and on the speaker.
Note: After you have finished listening to your external device, unplug the audio cable
from the Aux in socket on the back of your speaker.