Bushman Tank - Install Overflow Extension; Connect Overflow Pipe; Install Drain Valve

Next, locate the overow extension screen (①) for your tank. Install it onto the tank overow ng (②) by
pressing it on.
Next, locate the 3” white pvc 90 deg. elbow ng (①). Glue this to
the overow extension with the appropriate glue for abs/pvc. Aer that
measure and cut a length of 3” SDR-35 pvc pipe (②) that will convey
the water coming out the overow down and away from the building.
(This pipe is oponal and purchased separately at your own expense)
An overow pipe could also be connected back into area or french drain
systems located on the property.
Your tank will require a drain valve to be installed to release the water from the tank. This item is purchased
separately at your own expense. Here are a couple suggesons:
1. Add a ball valve (recommended) with a hose thread adapter.
2. Add a spigot.
①
②
①
②
Both of these connecons will require an adaptor ng or reducer to
aach. If uncertain about what to do please take a picture of the black
bulkhead ng with you to the store for reference. The opening of the
bulkhead on the boom of the tank is 1” NPT.