Bushranger Plugga III

To Next Page

INSTRUCTIONS

Remove debris from tyre tread or sidewall using

the pair of pliers provided in the kit. Take care,

as residual air will escape under pressure.

Apply lubricant to the spiral shaft of the reamer

tool. This will help to probe the hole and

temporarily seperate the steel belts.

Insert the reamer into the puncture hole and

push in to clean out the hole. Reinflate tyre to

help with insertion of cord.

Thread the repair cord through the eye of the

insertion tool until equal parts are either side of

the tool. Lubricant may be added to the tip to

make insertion easier.

Firmly push the insertion tool and cord into the tyre.

A small amount of the cord should be visible.

(50-10mm only)

Remove the tool, by slowly pulling up on the

handle. The cord should remain stationary in this

process. Note: do not twist the handle. Trim the

excess protruding cord with the blade provided.

Reinflate the tyre using a Bushranger compressor

to the recommended tyre pressure and check for

leaks.

Check the repair regularly and have the tyre

professionally checked and repaired as soon as

possible. Seals are only intended to be used as

temporary repair.

1. 2.

4. 5.

Need help?

Do you have a question about the Bushranger Plugga III and is the answer not in the manual?

Summary

Instructions

Prepare for Tire Repair

Remove debris, lubricate and clean the puncture hole using the provided tools.

Insert and Secure Repair Cord

Thread the repair cord through the insertion tool and push it into the tyre.

Finalize Tire Repair

Remove the insertion tool, trim excess cord, reinflate the tyre, and check for leaks.

Post-Repair Maintenance

Regularly check the repair and seek professional inspection for temporary seals.

Warranty Information

How to Make a Warranty Claim

Claims require the product to be returned with proof of purchase within the warranty period.

Warranty Exclusions

Details conditions not covered by the warranty, including improper installation or misuse.