| X Jack Guidelines
Page 1
PLEASE READ THESE GUIDELINES CAREFULLY BEFORE USING PRODUCT. FAILURE TO DO SO MAY RESULT IN SERIOUS
INJURY, DAMAGE TO PARTS AND/OR EQUIPMENT AND VOID YOUR WARRANTY.
Component List
Specications
Qty
1. X Jack
2. Carry Bag
3. Hose A
4. Hose B
5. Protective Mat
6. Instructions
7. Replacement Seal Kit
8. Protective Gloves
Material:
Inated Height:
Inated Diameter:
Maximum Capacity:
Total Kit Weight:
Reinforced PVC
750 mm
650 mm
2000 kg
9kg (X Jack only 5.4 kg)
1
1
1
3
1
1
1
1 Pair
X Jack must be inated and deated several times immediately after purchase. Please follow all the guidelines and
warnings before proceeding.
General Warnings
Important Notice
• It is highly recommended that prior to using this X Jack that users undertake off road training course including vehicle
recovery. Recovering immobilised vehicles is potentially a dangerous exercise and this X Jack is to be used with
great care.
• Ensure these guidelines have been read and understood prior to use.
• This X Jack is not suitable for all vehicle recovery circumstances.
• These are guidelines only and do not cover all situations, if in any doubt seek professional assistance.
• The equipment in the X Jack kit shall not be used for any purpose other than as described in these guidelines.
• Any trailer or caravan attached to vehicle shall be disconnected prior to operating X Jack.
X Jack will not inate vehicles with an acute angle exhaust. Vehicles with acute angle exhaust, for example: Toyota
Landcruiser 100 Series, Toyota Landcruiser 80 Series, and the Nissan Patrol GU. Please use the X Jack compressor feature to
inate or alternatively an ancillary extension pipe is available free of charge* by contacting customer service on
1800 654 767. This allows the rubber cone on the hose of the X Jack to t snug.
Dual exhaust vehicles will need to use the X Jack compressor feature to inate. *Australia only.
X JACK
72X10
7
6
2
5
8
4
3
1
To Next Page
Need help?
General