Moves your bricks. Fast. 5 UG_1.6 © 2021 BuWizz
3. First steps
BuWizz 2.0:
- After receiving BuWizz brick(s), please charge them first.
- Connect a micro USB cable to BuWizz (USB charger, computer, PowerBank battery,…).
- During charging LED may turn off, don’t worry BuWizz is still charging.
- When BuWizz is not connected to USB power, the LED will glow green regardless of battery
state.
- If BuWizz battery is depleted beyond level, suitable for normal operation, the LED will
alternate quickly between red and green for a few seconds, then BuWizz will turn off
- If BuWizz cannot be turned on by pressing the power button, then battery is completely
depleted or battery protection kicked in.
- In either of the cases above, please connect the charger – only briefly to reset the
protection circuit or for 2-3 hours to completely charge the depleted battery.
BuWizz 3.0
- After receiving BuWizz brick(s), please charge them first.
- Connect a USB C cable to BuWizz (USB charger, computer, PowerBank battery,…).
- During charging LED on PU port 1 will indicate charging.
- When BuWizz is not connected to USB power, the LED will glow/blink in the color of the
battery status.
- If BuWizz battery is depleted beyond level, suitable for normal operation, the LED on PU
port 1 will alternate quickly between red and green for a few seconds, then BuWizz will
turn off
- If BuWizz cannot be turned on by pressing the power button, then battery is completely
depleted or battery protection kicked in.
- In either of the cases above, please connect the charger – only briefly to reset the
protection circuit or for 1-2 hours to completely charge the depleted battery.
BuWizz can operate with charger connected. In fact, connecting a PowerBank type battery can
greatly extend the playtime and you can leave the battery connected to BuWizz while operating
your model.
NOTE: BuWizz turns off automatically after ~10 minutes if not in use (i.e. no commands are
received over Bluetooth connection).
To Next Page
Loading...
