Why do my BUXTON Headphone switch off automatically?
If your BUXTON Headphone automatically switches off, it's likely because the battery is nearly empty. To resolve this, allow the headphones to charge for 1 – 2 hours.
Why is there echo in my BUXTON REI-TW 100 mk2?
If you are experiencing echo in your BUXTON Headphone, it could be due to the volume being set too high or a noisy environment. Try adjusting the volume on your phone or moving to a quieter location.
What to do if the light indicators are not lit while charging BUXTON REI-TW 100 mk2?
If the light indicators aren't lighting up when charging your BUXTON Headphone, it might be because the headphones are incorrectly inserted in the base. Ensure the headphones are properly seated in the base and that the pins are correctly aligned. Also, try recharging the base.
What to do if there is no sound after pairing BUXTON Headphone?
If you're not hearing any sound from your BUXTON Headphone after pairing, the pairing process might have been incorrect. Try performing the pairing process again.
Why do I hear unpleasant sounds during a call with my BUXTON Headphone?
If you hear unpleasant sounds during a call using your BUXTON Headphone, it may be due to environmental interference or excessive distance between the headphones and your phone. Try moving to another location or bringing the headphones closer to your phone.
What to do if the charging light is not lit when charging the base of BUXTON REI-TW 100 mk2?
If the charging light doesn't light up when charging the base of your BUXTON Headphone, it could indicate that there's no voltage in the adapter. Make sure the charging micro USB cable is properly plugged in.
Why BUXTON Headphone doesn't turn on when removed from the base?
If your BUXTON Headphone doesn't turn on when removed from the base, or the light indicator isn't on when the base is charging, it could be due to low base battery. Allow the headphones and base to charge for 1 – 2 hours.
What to do if an error occurred while pairing BUXTON REI-TW 100 mk2 Headphone?
If you encountered an error while pairing your BUXTON Headphone, or if the TWS paired successfully but the right headphone didn't pair, it might be due to too many pairing records. Try deleting some pairing records.
What to do if I can not hear the speaker on BUXTON REI-TW 100 mk2?
If you can't hear the speaker when using your BUXTON Headphone, you might be wearing them incorrectly. Remove the headphones and put them on again correctly.
General| Driver Size | 10mm |
|---|---|
| Impedance | 32 Ohms |
| Frequency Response | 20Hz - 20kHz |
| Bluetooth Version | 5.0 |
| Water Resistance | IPX4 |
| Charging Time | 1.5 hours |
To Next Page
