Buydeem K821 - CLEANING AND MAINTENANCE; Cleaning and Maintenance

CLEANING AND MAINTENANCE SIMPLE TROUBLESHOOTING
Cleaning and maintenance Simple Troubleshooting
After boiling water, the minerals contained will be attached to the surface of the heating plate in the form of
powder or lumps, which is what we usually called water scale. It is recommended to clean it every month to Case Analysis Troubleshooting
avoid
reducing
the
heat
conduction
efficiency
of
the
heating
plate.
-
Do
ot
comect
1902
|
Croaewnetner
comect
o
e
power
No “beep” sound and | power
Step 1 Step2 the key light does not | The connector on the | When the power is connected, rotate the kettle
light up after installation | power base surface is | body to adjust the position to confirm it has been
. * Add fresh lemon sli vinegar or other
Add water to the machine to the MIN water line dd fresh lemon slices, vinegar or othe; Pot connected connected successfully
weak acidic substances
The screen displays EL | NTC failure
Please contact the service center of purchase
channel which authorized by BUYDEEM for
replacement or repair
The screen displaysE2 | Long boiling time
The screen displays E3 | Heating plate failure
Before using the new product, itis recommended
Step3 Step4 to boil the water several times and pour it out. If
= Start boiling water to 100°C « Allow to stand for 5-10 minutes after Waterhasastrangesmell | Unused new product | the situation keep occurring, fill the machine to
automatic power off the MAX line and add two tea spoons of baking
soda, boil it and pour it out, then clean the
product
Step 5
« Finally, wipe the inside bottom of the
machine with Buydeem cleaning brush
Any other servicing should be performed by an authorized service representative.
10 1