Buydeem K821 - Function Introduction

UNDERSTANDING PRODUCT
Function Introduction
-
convert °F and °C
2.Click to display the timer and 1. Rotate to adjust the temperature
start brew timing of boiling and warming
3.click again to clear the timer 2. Press to start/pause boiling water
and exit the timer interface 3. Long press to turn off the machine
Click to turn off the
key tone / end beep
Lpress and hold for 25 to
Function Symbol | Function Name Operation Instruction
1. Rotate to select expect water temperature. By turning clockwise,
Variable | the settemperature will be increased and vice versa
Temperature | 2. Press to start boiling water.
Control | 3. Press again to pause boiling water.
+ ~ | &Boiling Water| Note: Do not heat liquids other than water to avoid overflowing or
sticking to the bottom.
Mute Click to turn off the key tone and end beep.
1. Press and hold for 2s to convert °F and °C
2. Click to start the brew timing and click again to clear the timer
I°F/°C Convertion|
& function.
S Timer Note: This function is independent of the boiling water function.
The machine will keep warm automatically for 1.5 hour after boiling
water by default. If you don’ t need the automatic warming
Cancel | function for a long time, disconnecting the power firtly, then
neetic
|
pressing
the
Mute]
button
and
holding
on
and
then
re-powering
at
Warming the same time. When there is one “beep” and the white screen
Function shows, it indicates that automatic warming function has been
cancelled. If you need re-start the automatic warming function,
repeat above steps and when there is one “beep” and the screen
shows “WARMING” , this function has been active.
NOTE: The kettle body and the power base of K821 must be used together. Do not mix other brands of
kettle or other models of BUYDEEM kettle with k821 s power base, otherwise it may not work properly, or
even trigger short circuit, electric shock and other dangers.
8
USING PRODUCT
Please do the boiling point test before first use
In areas where the altitude is higher than 250 meters, the water will boil before it reaches 100°C and the
water temperature will stop rising, where it is difficult for the machine to recognize and it will stop boiling
water. Therefore, before using the machine for the first time, please conduct a boiling point test.
Step 1 Step 2 Step3
= Add water to the MAX = Disconnect the power, then = When the screen shows [HE] , which
press and hold the "Mute" and meansthe machine has entered the boiling
"Timer" buttons at the same point test. It takes about 5 minutes, and the
time and power on the machine. machine wil be automatically shut down
Do not touch other function after the test is completed. Pour out the
keys before that. water and you may use it normally.
water line of 0.8L,
|| MAX 0.8L
A
Cold Water Identification Function
If the cold water is added to the machine while the machine is boiling water, it will be identified and reheat
tothe specified temperature, so there is no need to worry about half-heated
Automatic Shutdown
If the machine does not run the boiling or warming program, it will automatically shut down after 10min for
electricity safety.
Program Memory Function
When the kettle body is lifted during the boiling process and put back again within 10min, the machine will
continue to work in the previous state without user's repeated operation.
Boil-Dry Protection
Please keep the amount of water above the MIN water line. Don’ t worry for dry boiling if there isn’ t
enough water. The machine will stop heating automatically after recognition for electricity safety. At this
time, some marks of ry boiling may appear on the bottom of the machine (dark small spots), but the actual
performance will not be affected.