www.buyersproducts.com
Phone (440) 974-8888
Fax 800-841-8003
Installation Instructions
Bill of Materials
ITEM PART NO. QTY. DESCRIPTION
1 3030321 1 Rack, Locking Gas Can, Only
2 3004396 3 Screw, Button Head, 3/8" x 1-1/4", Zn
3 FWF038100007 3 Washer, Flat, 3/8" UUS, Zn
4 FNE038016044 3 Nut, Nylock, 3/8", Zn
5 3005729 1 Pin, Lock, Gas Can Rack
6 3005730 1 Lock, 1-1/2" Pad w/ Keys
WARNING
Check for locations of brake lines and electrical wiring etc.,
before drilling any holes. Any damage to trailer during instal-
lation is the installer’s sole responsibility.
—continued inside
CAUTION
Always wear safety glasses when using power tools
LT32 Locking Gas Can Rack
Designed to work with the following gas cans:
• Blitz USA Inc. 5 gal and 6 plus gas cans
• Midwest Can Co. 5 gal cans
Models 5600, 7600, & 8600
• No-Spill Inc. 5 gal cans
Models 1058, 1450, 1456, & 1457
Before you begin installing:
1. Read and understand these instructions
completely.
2. Verify that you have received all the parts
listed in the bill of materials.
Utility Trailer Installation Instructions
Tools and Materials Required:
• 9/16" Wrench or Socket
• 7/32" Hexagon Allen Wrench
• Electric Drill
• 3/8" Drill Bit
1. Place the gas can rack on the rail of your
utility trailer where you would like it mounted.
Make sure the rack does not extend past the
widest part of the trailer. Align the holes in the
bottom of the gas can rack with the center of the
rail.
2. Mark the position of the three holes on the
trailer rail.
3. Drill 3/8" holes in the positions marked.
4. Bolt the rack to the trailer with three 3/8-16
X 1-1/4 socket head cap screws, six 3/8" flat
washers, and three 3/8-16 nylock nuts supplied
and tighten.
5. Assemble the lock pin to the gas can rack
through the two 1/2" holes in the tabs. Align the
5/16" hole in the lock pin with top hole in the gas
can rack and assemble lock.
Fig. 1
To Next Page
Need help?
General