Table of Contents
General Information .................................................. 1
Safety Precautions ..................................................... 1
Warranty Information ............................................... 2
Installation Instructions ..................................... 2-4
Spreader Operation ................................................... 5
Spreader Maintenance ............................................. 5
Repair Parts & Drawings ..................................... 6-10
General Information
Spreader models:
SHPE2000- spreader with standard length chute;
SHPE2000X- spreader with extended length chute.
Overall Length: 96 inches
Overall Width: 47-1/2 inches
Overall Height (installed): 40 inches
Empty Weight: 437 lbs (standard chute), 441 lbs
(extended chute)
Capacity Struck: 2.0 cu. yd.
Vehicle Requirements
3/4 or 1 ton pick-up truck above 8500# GVWR.
135 AMP or higher alternator is recommended.
Average Material Weights
Note: To calculate the total spreader weight (including ice
control material), add the empty spreader weight plus the ice
control material and spreader accessories.
Safety Precautions
1. Read this entire Owners Manual before operating
this spreader.
2. Read all safety decals on the spreader before
operating.
3. Check to make sure all safety guards are securely
mounted into place before operating this spreader.
4. Verify that all personnel are clear of the spreader
spray area before starting or operating this spreader.
5. Do not over-load your vehicle beyond payload limits.
If there are any questions, contact the vehicle
manufacturer.
6. Do not adjust, clean, lubricate or unclog material
jambs without first turning off the spreader.
7. Do not climb on or in the spreader during operation.
Do not ride on the spreader while the vehicle is
in motion.
8. Make sure the spreader is securely fastened to the
vehicle in accordance with this manual.
9. Do not operate a spreader that is in need of mainte-
nance or repairs.
10. Always disconnect the battery before removing or
replacing electrical components.
Instruction Manual
Salt Dogg
Spreader Hopper Poly Electrical
2.0 cubic yards
WA RNING
Observe the following Safety Precautions before, during and
after operating this spreader. By following these precautions
and common sense, possible injury to persons and potential
damage to this machine may be avoided.
Fine Salt-Dry 2,250
Coarse Salt-Dry 1,431
Sand/Salt 50/50 Mix-Dry 2,700
material weight (pounds per cubic yard)
Quality since 1946
9049 Tyler Blvd. • Mentor, Ohio 44060
Phone (440) 974-8888 • Fax (440) 974-0165
Toll-Free Fax 800-841-8003 • buyersproducts.com
CAUTION
Do not overload vehicle beyond the vehicle’s GVWR or GAWR.
Check vehicle's load rating certification sticker for maximum
vehicle capacity.
To Next Page
Need help?
General
