DESCRIPTION
The AIR-EAGLE XLT is an RF system designed for medium to long range
wireless remote control of electrical apparatus in a variety of industrial
applications. Systems can consist of any number of receivers and
handheld or contact input transmitters working together. This receiver is
equipped with 4 independent relays that can switch 5 amps @ 120VAC or
30VDC. The relays are user programmable for momentary or
toggle/latching operation and can be directly interfaced with the
customer's equipment or P.L.C. Seven user selectable frequencies allow
multiple systems to be used in the same area. Capable of receiving
remote signals transmitted from up to 2500 feet away (with the handheld
transmitter) or up to 2 miles away (with the contact input transmitter), the
Air-Eagle XLT utilizes spread-spectrum technology and provides the
utmost security and reliability even in the noisiest RF environments.
SERIES FEATURE
The “441” Series features repeating capability. Transmitters can be set
up to send “repeat signal packets”, and any transmitter or receiver
within its range will repeat the signal packet to help propagate
communication over widespread areas.
APPROVALS
INSTALLATION
DISCONNECT DC Power from all equipment before installation.
1. Mount the AIR-EAGLE XLT RECEIVER in a convenient location.
2. Install relay wiring to terminal strip.
3. Install antenna onto connector located on the right side on the
enclosure.
4. Connect supplied power input cable to your external power source.
TERMINAL STRIP WIRING
Relay #1 contacts are shown in their de-energized state. When power is
applied to the unit, relay #1 will energize. The relay will then de-energize
when a signal is received from the transmitter.
To Next Page
General