What to do if the red LED is on and BWT Medo XB4 Water Pump stops?
If the red LED indicator lights up and the BWT Water Pump stops, it could be due to a low liquid level in the storage tank. Refill the storage tank. Alternatively, if an external cable is connected while the multifunctional switch is not set to "Extern," either switch to "Extern" or disconnect the external cable.
Why BWT Medo XB4 Water Pump does not prime after bleeding?
If the BWT Water Pump doesn't prime despite full stroke motion and bleeding, it might be due to minor or major crystalline deposits on the ball seat because the valves are drying out. * For minor deposits, flush out the liquid end thoroughly by removing the suction hose from the storage tank. * For major deposits, dismantle and clean the valves.
What to do if yellow LED lights up on BWT Medo XB4?
If the yellow LED indicator lights up on the BWT Water Pump, it means the liquid level in the storage tank has reached the "liquid level low 1st stage". To resolve this, fill the storage tank.
What to do if fluid is escaping from the backplate of BWT Medo XB4?
If fluid is escaping from the backplate of your BWT Water Pump, it could be due to: * Loose screws in the dosing head: Tighten the screws crosswise. * A loose metering diaphragm: Replace the diaphragm.
How to fix BWT Medo XB4 Water Pump when green LED is off?
If the green LED display (operating display) does not light up on your BWT Water Pump, the wrong or no mains voltage is connected. Connect the pump correctly to the specified mains voltage as indicated on the nameplate.
Defines signal words (WARNING, CAUTION) and warning signs.
Outlines rules for proper pump usage and prohibited applications.
Details critical warnings for personal, electrical, fire, and chemical safety.
Provides instructions for actions in emergency situations.
Details individual control elements like switches, knobs, and indicators.
Guides on connecting the pump to the mains power supply and parallel connections.
Explains the function and wiring of the external control and level switch terminals.
Lists faults that occur without an indicator light and their solutions.
Describes causes and remedies for red LED fault indicators and pump stops.
Explains causes and remedies for yellow LED warning indicators.
General| Insulation Class | F |
|---|---|
| Frequency | 50 Hz |
| Housing Material | Cast iron |
| Application | Water supply, irrigation |
| Impeller Material | Stainless Steel |
| Suction Lift | 8 m |
| Voltage | 230/400 V |
| Inlet/Outlet Size | 1 inch |
To Next Page
