F3/F3R OWNER’S MANUAL
- 74 -
Remember. In most cases, the slower the
engine speed is, the fewer the fuel
is consumed.
When the ignition switch is in “START”
position, there is no malfunction even if the
engine coolant temperature gauge needle
returns to “0”.
NOTICE
Do not let the indicator needle get
into the red zone. This may cause
severe engine damage.
Odometer and two trip meters
This meter displays the following
information:
1. Odometer — shows the total distance
the vehicle has been driven.
2. Two trip meters — shows two different
distances independently driven since
the last time each trip meter was set to
zero.
You can use one trip meter (TRIP A) to
calculate the fuel consumption and the
other (TRIP B) to measure the distance
on each trip.
3. Trip meter reset knob — resets the two
trip meters to zero, and also change the
meter display.
To change the meter display,
quickly push and release the knob. The
meter displays changes in the order
To Next Page
Loading...
