Bye Bye Standby BBSLP User Manual

Set-up
1. Insert your Bye Bye Standby socket into an electrical mains socket.
2. Each socket must be set-up with a remote before it can be used. To set-up your socket with your remote control press and
hold the OFF buon on the socket. The LED on the socket will flash once every second indicang that it is ready to be set-up.
3. Choose one pair of buons on your remote control to control your socket. Press and hold the green ON buon on your
remote control, the LED will flash rapidly and then remain on, this indicates that your socket is ready to be used.
Bye Bye Standby is a trading name of Enisc Ltd
10 Wornal Park, Worminghall Bucks, HP18 9PH
www.enisc.com
For further informaon on the Bye Bye Standby
range of energy saving products, please visit
www.ByeByeStandby.co.uk
Technical Specificaons
Voltage: 240VAC/50Hz
Rang: Max 13A/3000W
On/Off Indicaon: LED
Range: <30M
Baery Type: 12VDC/MN21
Important
For indoor use only. Keep away from
all sources of water and moisture. Do
not overload. Adult Installaon only.
Use only as directed. Always check
waage load and do not exceed the
electrical devices specificaon
1
2
3

Bye Bye Standby BBSLP Specifications

General

Product color	White
Current rating	13 A
LED indicators	Power
AC input voltage	240 V
Connector gender	Male/Female
Sockets quantity	1
AC input frequency	50 Hz
Plug connector type	Type G (UK)

Weight and Dimensions

Depth	95 mm
Width	152 mm
Height	205 mm
Weight	259 g

Summary

Socket Set-up Guide

Insert Socket

Insert the Bye Bye Standby socket into an electrical mains socket for initial use.

Pair Socket with Remote

Pair sockets by holding the OFF button on the socket until the LED flashes, indicating readiness.

Confirm Pairing

Confirm pairing by pressing the ON button on the remote; rapid LED flashes indicate successful setup.

Using Your Standby Socket

Operate Appliance

Plug in your device and use the green button to activate standby or the red button to turn it off.

Master Power Control

Utilize the ALL ON and ALL OFF buttons to control all paired sockets simultaneously.

Socket Reset and Troubleshooting

Initiate Socket Reset

Turn the socket off, then hold the remote's OFF button for three seconds to begin the reset process.

Complete Socket Reset

Hold the ALL OFF button until the socket's LED flashes rapidly, then once per second, to complete the reset.

Remote Control Issues

Address non-responsive remotes by checking battery charge or proximity to the socket.