11
b. Cumulative discharge power (AH)
This parameter is the discharge AH counter, which shows the power consumption of the
load. In this interface, press " "and hold for more than 5s, the counter can return to
zero.
Accumulated Discharging Power (AH)
c. Float voltage setting
Press " " to join the float voltage menu. Long press the " " key ≥ 5S, the
interface parameter is flash, here is the setting state. Release the button and press the “
" key to add data, and press the " " key to subtract data. After completing the
required technical data, long press the " " key again, ≥5S, the parameters will be
saved and enter the setting state. If there is no operation for 20s, it will automatically
return to the main interface.
d. Low voltage recovery operating voltage (LVR)
When the battery voltage is low, the controller stops supplying power to the load. If the
controller needs to reconnect the output, the battery voltage must be higher than the
LVD voltage or press the " " key to release. The procedure is the same as (c).
Load disconnect voltage
To Next Page
Loading...
Need help?
General
