Why is my Byond ResPlus C-20A CPAP Humidifier excessively loud?
If your Byond Humidifier is excessively loud, it might be due to the tube not being connected properly or leaks in the mask or tubing. Reconnect the tubing and ensure there are no leaks.
What to do if my nose and/or throat are dry and/or irritated when using Byond Humidifier?
If you experience dryness or irritation in your nose and/or throat while using the Byond Humidifier, it could be due to dry air in the room. Try turning up the humidifier level or consult your doctor.
What to do if I have eye irritation or dryness using Byond Humidifier?
Eye irritation or dryness while using the Byond Humidifier may occur if the mask model or size isn't suitable, or if the mask is positioned incorrectly, causing air to blow into your eyes. Adjust the mask position and the headgear's tightness. Consult your doctor to replace the mask. If the mask is old or broken, replace it immediately. Try another mask model.
What to do if the air output of my Byond Humidifier is too hot?
If the air output from your Byond Humidifier is too hot, the air filter might be clogged with dirt, or the air inlet is blocked. The device might also be too close to a wall, curtains, or other obstructions. Check and clean the air inlet, replace if necessary. Reposition the device at least 2 inches away from any obstructions.
What to do if I have water in the mask of my Byond Humidifier?
If you find water in the mask of your Byond Humidifier, it may be because the room temperature is too low, or the humidifier output air is condensing in the tube. Lower the humidifier setting, increase the room temperature, or place a towel or blanket over the tube to maintain the temperature of the output airflow.
Why does my Byond Humidifier beep after turning on?
If your Byond Humidifier beeps after being turned on, the power supply might not be connected properly. Disconnect the power plug and reconnect it.
What to do if I have face reddening or inflammation using Byond ResPlus C-20A CPAP Humidifier?
If you experience face reddening or inflammation while using the Byond Humidifier, the headgear might be too tight, the mask model or size may not be suitable, or you may be allergic to the mask materials. Loosen the headgear and ensure a proper fit. Consult your doctor.
What to do if the air flow output is too low on Byond ResPlus C-20A CPAP?
If the airflow output of your Byond Humidifier is too low, and the “Ramp” function is on, it may take time for airflow to rise from the initial pressure. The air inlet may also be blocked. Turn off or change the settings of the Ramp feature. Check and clean the air inlet or replace the air filter.
What to do if nothing displays on the screen of my Byond Humidifier?
If nothing displays on the screen of your Byond Humidifier after turning it on, the power supply may not be connected properly. Disconnect the power plug and reconnect it.
Why can't the pressure be set on my Byond Humidifier?
If the pressure can't be set on your Byond Humidifier, the Ramp feature might be on. Turn off the Ramp feature, then reset the pressure.
Device purpose for positive airway pressure for patients with respiratory insufficiency or OSA.
Cautions about substantial risk of injury if warnings are not followed; general safety advice.
Conditions where the device should not be used or used with caution.
Step-by-step guide for initial setup and connection of the device.
Instructions for routine daily operation and assembly.
Illustrates and labels the components of the humidifier unit.
Instructions for attaching and detaching the humidifier from the main device.
Describes the main display screen and its icons.
Explains how to access and use the PFCurve interface screen.
Details how to unlock and access the parameter setting interface.
Instructions to navigate and adjust system settings like time, date, and brightness.
How to view usage data like UseTime, AvgPress, AHI, etc.
Instructions for the Epworth sleepiness scale questionnaire interface.
Recommends the frequency for cleaning and replacing parts.
Provides instructions for cleaning the host, tubing, water tank, and air filter.
Guidelines for disinfecting the device components.
Recommendations for preparing the device when changing users.
General| Operating Pressure | 4-20 cm H2O |
|---|---|
| Data Storage | SD Card |
| Water Tank Capacity | 300 ml |
| Humidification Level | Adjustable |
| Heating Element | Integrated |
| Humidification | Integrated |
| Voltage | 100-240V AC |
| Compatibility | Standard CPAP masks |
| Power Source | AC Adapter |
To Next Page