RAPID GET YOU GOING INSTRUCTIONS
1. Assemble and adjust for length (Twist surplus lead around stem).
2. Insert batteries.
3. Set DISC 1 (top right) to ALL METAL (fully anticlockwise).
4. Set DISC 2 (bottom far right) to 5.
5. Set SENSITIVITY (top left) to 3 o'clock position.
6. On CS5MX only:-
Push BATT CHECK down and hold to indicate battery condition. Good batteries
will be in the green area on the meter. Release.
7. On CS5MX only:-
Set BOOST to NORMAL.
You are now in ALL METAL MOTION MODE.
You will find all metals within the search head range including iron and trash
PROVIDING THE SEARCH HEAD IS MOVING OVER THE TARGET
(not stationary).
To ignore low value metals (iron & trash)
:-
8. Adjust DISC 1 (top right) to position 5.
You are now in DISCRIMINATING MOTION MODE.
The other modes require more detailed explanation acquired from reading the full
instructions.
IF A PROBLEM IS ENCOUNTERED REFER TO THE FULL INSTRUCTIONS.
1
To Next Page
Need help?
General
