Need help?Do you have a question about the C-SCOPE SGV4 and is the answer not in the manual?
General| Type | Metal Detector |
|---|---|
| Detection Depth | Varies with target size and ground conditions |
| Weight | 1.3 kg |
| Operating Frequency | 7.2 kHz |
| Depth Measurement | Yes |
| Length | Adjustable |
| Depth Indicator | Yes |
| Discrimination | Yes |
| Ground Balance | Automatic |
| Power Supply | Battery |
| Search Coil Size | 20 cm (8 inches) |
| Battery Type | AA |
| Battery Life | 20 hours |
| Target Indicators | Audio and visual |
Identifies and explains the controls, display, and parts of the CXL4, DXL4, and MXL4 Locators.
Details the various components of the SGA4/SGV4 Signal Generator and MXT4 Transmitter.
Explains how the Locator detects power signals and its limitations in Power Mode.
Details how the Locator detects radio signals and the limitations of Radio Mode.
Explains the All Scan Mode for detecting signals across all frequencies and its benefits.
Describes using the Locator with a Signal Generator/Transmitter and application methods.
Details how to check, replace, and manage batteries for the C.Scope Locators.
Explains the self-test function, its indicators, and how to handle PASS/FAIL/OVER errors.
Provides instructions on the correct way to hold the Locator during operation for optimal performance.
Details the steps for searching for buried services using the Locator in various modes.
Explains the procedure for accurately pinpointing the source of a detected signal.
Guides the user on how to trace the identified route of a buried service.
Describes different methods for applying signals to buried services using accessories.
Details the process of applying a signal directly to a metal pipe using connection leads and an earth stake.
Details direct connection setup, including earth stake use and connection quality indicators.
Introduces C.Scope Sondes, their types, and how they are used to locate non-metallic pipes.
Details the technique for tracing a Sonde using the Locator, including setup and alignment.
Details the Sonde tracing procedure, including identifying true vs. ghost signals and repeating pinpointing.
Details how to perform depth measurements on metallic services using DXL4 and MXL4 Locators.
Details limitations and error codes for metallic service depth measurements.
Explains depth measurement for non-metallic pipes using Sondes, Tracers, and Locators.
Details limitations and error codes for non-metallic pipe depth measurements.
To Next Page
