Need help?Do you have a question about the C-SCOPE XD and is the answer not in the manual?
Details on using the locator in Power Mode to detect live cables.
Details on using the locator in Radio Mode to detect re-radiated signals.
Details on using the locator in Generator Mode with a signal transmitter.
Instructions for checking and changing batteries in the locator.
Proper grip and orientation for accurate signal detection.
Method for conducting an initial search for buried services.
Technique for precisely locating the buried service.
Method for following the identified service route.
Applying a signal directly to a metallic service using leads.
Using accessories to apply signals without direct contact or via power outlets.
Inducing signals onto services without physical connection.
Using the Sonde transmitter to locate non-metallic pipes.
Using the Plastic Pipe Tracer with a signal generator for line tracing.
Specific procedure for depth measurement with sonde or tracer.
Procedures for testing the operational readiness of the Signal Generator.
Advice on careful handling to maintain accuracy and prevent damage.
Instructions on how to clean the equipment safely.
Recommendations for storing the equipment in optimal conditions.
To Next Page
General