1.
See Owner’s Manual and assembly videos on
www.c3customcoolers.com/p/ownersmanual
2.
• Install batteries in remote
• Switch cooler power to OFF position
• Hold down Pairing Button until LEDs fl icker, continue holding
• Turn cooler ON (the motor will buzz when paired)
• Release Pairing Button
3.
1.
2.
3.
Before first use, you MUST
If you experience any issues, please
complete the steps below prior to
contacting customer service
complete the steps below!
Pairing Button
See inside of this Quick Start Guide
Rough shipping & handling may loosen electronics connections
• Switch cooler power to OFF position
• Remove four screws attaching large, plastic access panel
• Ensure all wire connectors are tightly connected
• Replace access panel
See Owner’s Manual: www.c3customcoolers.com/p/ownersmanual
Do not return product to store. Contact customer support
for assistance at 1-844-723-4909 or c3@seljan.com.
Assemble Wheels
Pair Remote to Cooler
Charge Battery 10-12 hrs
Complete quick start steps
Check connections
Refer to troubleshooting guide
Remote Control Cooler
Applies to Models: ROVER, TRUCK, ZAMBONI
Styles and Colors May Vary
Designed, Molded and Assembled in the USA
Reference full owner’s manual at
WWW.C3COOLER.COM/P/OWNERSMANUAL
MAXIMUM LOAD CAPACITY 60 LBS
DO NOT SIT ON COOLER
Quick
Start Guide
FULL
MANUAL
ONLINE
To Next Page
Need help?
General
