1
1
Clean the gaskets carefully.
Do not use aggressives detergents or abrhasive products.
Softly wet the surfaces by the use of a brush. It is recommended to proceed
with the cleaning of all gaskets with abundant water.
NOTE: Do not use too hot water to clean the plastic components .
CLEANING OPERATION
Pic. 33
Pic. 32
Pic. 34
Pic. 35
1 - Pull out the pin
for handle fixing
(see Pict. 32).
3 - Unthread the
main tap pin by
pulling it downwards
(see Pict.34)
2 - Pull the handle
from its place
(see Pict. 33).
4 - Repeat the
same operation for
the tap spring
(see Pict. 35)
How to clean each part
How to remove and clean the tap components
Clean the suction
cap gasket as
shown
in Picture 36.
clean the lower
gasket for tap as
shown
in Picture 38
Clean the tap o-ring
on both sides as
shown in Picture
37.
clean the bowl
gasket along all the
edges as shown in
Picture 39
Pic. 36
Pic. 37
Pic. 38
Pic. 39
34
To Next Page
Loading...
Need help?
General
